JB Systems Light LED illusion Manual De Instrucciones página 6

ENGLISH
OPERATING INSTRUCTIONS
 Once connected to the mains the device starts running.
 Always unplug the unit when it is not used for a longer time or before to start servicing.
 In the event of serious operating problems, stop using the fixture and contact your dealer immediately.
 Important: Never look directly into the light source! Don't use the effect in the presence of persons
suffering from epilepsy.
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
Mains Input:
Power consumption:
Fuse:
Sound Control:
Lamp:
Size:
Weight:
You can download the latest version of this user manual on our website: www.beglec.com
JB SYSTEMS
®
AC 100~240V, 50/60Hz
6,5 Watt
250V T1A slow blow (20mm glass)
Internal microphone
63 x 0.1W LEDs (21xRed, 21xGreen, 21xBlue)
328 x 456 x 216mm
3,8 kg
The information might be modified without prior notice
4/24
OPERATION MANUAL
LED ILLUSION