EnviroBoss EB140 Manual De Instrucciones página 2

CONTROLS AND OPERATING
INSTRUCTIONS
Set unit upright
NOTICE: Always store, transport, and use the unit in
an upright position. If the unit is ever placed on its
end or side, return it to the upright position and let it
stand for at least 30 minutes before turning it on.
Positioning a Dehumidifier
For best results, operate your dehumidifiers in an en-
closed area. Place your dehumidifier away from obstruc-
tions, and keep it away from anything that could block
airflow into and out of the unit. For more information
about creating an optimum humidity control environment,
contact EnviroBoss at 800-932-3030.
TIP: Before installing in a difficult-to-access location,
plug in the unit and run it for approximately half an hour
to ensure proper operation.
Set up drain hose
The EB140 condensate pump connects to a plastic drain
hose equipped with a quick-connect fitting for quick at-
tachment to the unit. To set up the hose, unwrap the en-
tire hose and place the unattached end in a sink, drain,
bucket or outdoors – anywhere that water can drain out
safely. Connect the other end of the hose to the EB140.
If you use a bucket or other container for water collec-
tion, check it regularly to prevent overflows.
NOTICE: Uncoil and straighten the entire drain hose. Do
not leave any part of the hose coiled and do not place
the end of the hose higher than 3 ft. (1 m) above the bot-
tom of the unit. Also check for kinks or other obstructions
that might restrict the flow of water. Obstructions may
cause a water backup and result in overflows.
Plug in electrical cord
The EB140 should be plugged into a GFCI-protected
115 volt outlet rated for at least 15 amps. Always plug
the cord firmly into the unit first, and then plug the other
end into a suitable outlet.
Startup display and normal display modes
When unit is first plugged in to AC power, the control
panel display will briefly cycle through a series of
readouts. This is part of the unit's self-diagnosis proce-
dure and no user intervention is required.
Turn the unit on
The control panel on the EB140 dehumidifier has a dis-
play and a touchpad with four keys. Press the
ON/OFF to turn the unit on. The unit will now go
through a compressor delay countdown (up to sixty sec-
onds in duration) and a self-diagnostics process.
07-02183A EB140
Fig. A: Parts Identification
Air inlet
Condensate
drain quick-
connect
Once the compressor delay countdown and self-diag-
nostics are complete, the display will switch to normal
display mode.
HUMIDISTAT
INLET 00°F / INLET 00%
The first line of the display shows that unit is humidistat
mode. The second line of the display alternates be-
tween inlet temperature and inlet humidity.
User Settings Menu
A number of display settings may be changed by the
user. System information can also be displayed. These
items are accessed by pressing
Each press of the key will display the next parameter.
When you reach the parameter you wish to adjust, press
MENU SELECTION to increase the value. Press
DISPLAY MENU again to accept the setting and re-start
the display cycle.
Note that only menu items followed by a greater-than
symbol ( > ) may be adjusted.
2
Control
panel
Air outlet
Power
socket
Temp/RH
sensor
Remove/Insert
air filter here.
DISPLAY MENU.
Legend Brands.