Step 1 - Rear Axle And Brake Assembly - Foundations LX3 Instrucciones De Montaje Y Uso

STEP 1 - Rear Axle and Brake Assembly

1.
Lay folded Stroller Frame Assembly (A) on
clean floor with handle tube on top and front
footrests contacting floor (Fig. 1).
2.
Assemble Rear Axle Tube Assembly (C)
to stroller (Fig. 2).
- Position Rear Axle Tube with brake
tube up and open end of rear axle
assemblies toward rear legs.
- Slide rear axle tube assembly onto the
lower ends of rear legs until contacting
spring pins. Press spring pins and slide
rear axle assembly onto rear leg until
spring pins snap into holes in rear axle
tube assembly.
- Pull on rear axle assemblies to check that
Rear Axle Tube is secured onto rear legs.
3.
Assembly of runaway brake cable to brake levers
at rear axle assembly.
- Remove package materials from stroller handle
and move runaway brake handle away from
stroller handle (Fig. 3) to extend the brake
cable at the rear axle.
- Push up on the brake lever
round end of the brake cable under the two
tabs on the brake lever link, slide brake
cable into slot on brake lever
release brake lever link keeping round end
behind tabs and brake cable in slot (Fig. 4).
- Repeat on other side of stroller.
- Check brake operation. Move runaway
brake handle down and up (Fig.5). Brake
lever on both sides should move up and
down when handle is moved.
1 , position
and then
2
Runaway
Brake
Handle
Brake
Lever
Handle
Tube
Footrest
Style May Vary
Brake
Tube
Rear
Axle
Tube
Rear Leg
Runaway
Brake
Handle
Slot
Tabs
Brake
Lever
Link
1
2
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Brake-
Cable
Round
End
Fig. 5
4