Sander Specific Warnings; Placing Tool In Service - Craftsman professional 235.19906 Manual Del Propietário

WARNING
can cause severe personal injury or death if the warning is ignored.
CAUTION
is used to indicate the presence of a hazard which will
or can cause minor personal injury or property damage if the cau-
tion is ignored.
NOTICE
is used to notify people of installation, operation or main-
tenance information which is important but not hazard related.
This Craftsman Sander is de-
signed to prepare metal and wood
surfaces for painting and finishing
operations.
WARNING:
Important safety information en-
closed.
Read this manual before operating
tool.
It is the responsibility of an em-
ployer to place the information in
this manual into the hands of any-
one who operates this device.
Failure to observe the following
warnings could result in injury.
SANDER SPECIFIC
WARNINGS
These Sanders will operate at
the free speed specified on the
label if the air supply line fur-
nishes 90 psig (6.2 bar/620
kPa) air pressure at the tool.
Operation at higher air pressure
will result in excessive speed.
Use only a sanding pad, buffing
wheel or polishing bonnet with
these tools. Do not use any
grinding wheel, bur or metal
removing accessory with these
tools. Never use an accessory
having a maximum operating
speed less than the free speed
of the Sander in which it is
being used.
is used to indicate the presence of a hazard which
When using a pad having a
shank, insert the shank to full
depth in the collet. When using
a pad on a threaded arbor,
make certain the flange nut is
tightened securely. Check the
tightness of the collet nut or
flange nut before operating a
Sander to make certain it will
not loosen during operation.
NOTICE:
The use of other than
genuine Craftsman replacement
parts may result in safety hazards,
decreased tool performance, in-
creased maintenance, and may
invalidate all warranties.
Repairs should be made only by
authorized trained personnel.

PLACING TOOL IN SERVICE

Always operate, inspect and
maintain this tool in accordance
with all regulations (local, state,
federal and country), that may
apply to hand–held/hand–oper-
ated pneumatic tools.
For safety, top performance,
and maximum durability of
parts, operate this tool at
90 psig (6.2 bar/620 kPa) maxi-
mum air pressure at the inlet
with 5/16" (8 mm) inside diame-
ter air supply hose.
Always turn off the air supply
and disconnect the air supply
hose before installing, removing
or adjusting any accessory on
this tool, or before performing
any maintenance on this tool.
4