Craftsman professional 235.19906 Manual Del Propietário página 6

3.Install the central vacuum on
Eductor Assembly (5).
See Figure 2.
5
For Use With Vacuum Bag:
1.Remove Muffler (2) and Plug
(4).
2.Install the Eductor Assembly
(5). Insert the tapered section
of the Eductor Assembly into the
Housing (1) while aligning the
threaded section with the
Housing. Using a wrench on
the flats, tighten the threaded
Air Supply and Connections
Always use clean dry air. Dust,
corrosive fumes and/or excessive
moisture can ruin the motor of an
air tool. An air line filter can greatly
increase the life of an air tool.
Operating the Sander – With the
Sanding Pad on the work to be
sanded, grasp the Sander by the
Grip Ring with the palm of your
hand over the Lever. To begin
Sanding, apply pressure to the
Lever. To stop Sanding, release
the pressure on the Lever.
7
Figure 2
Main lines 3 times air tool inlet size.
To air system
To air tool
Lubricator
Regulator
Drain regularly
Branch line 2 times air
tool inlet size
section securely. The tabs will
snap into slots in the Housing.
3.Install the Vacuum Bag (6) on
the Eductor Assembly (5).
See Figure 3.
6
NOTICE:
Before installing the
Eductor Assembly, make sure that
the Air Regulator (7) is installed
with the adjustment knob facing
away from the ports in the Hous-
ing. If the Air Regulator is not
installed in this manner, the adjust-
ment knob will block the installa-
tion of the Eductor Assembly.
The filter removes dust and mois-
ture. Be sure all hoses and fittings
are the correct size and are tightly
secured. See Figure 4 for a typical
piping arrangement.
Filter
Compressor
SPECIFICATIONS
Model Free
Speed
RPM
19906 12,000
6
7
5
Figure 3
Figure 4
Pad Diameter
in mm
6 152