Maintenance; How To Dismantle & Reassemble Tool; Rubber Bushing Replacement - Pearl Abrasive MPS100 Manual Del Propietario - Operador

viii. MAINTENANCE
HOW TO DISMANTLE THE TOOL
HOW TO REASSEMBLE THE TOOL
IMPORTANT: Make sure that the bearing on the
motor shaft is positioned all the way in the rubber
cup #0050 using oil. When starting up the scraper
if it is noisy check the rubber part # 0050.
Length of bolts must be maintained. Cap nuts make the
adjustment, they are not to be replaced with standard
nuts.
When assembling cap nuts, apply a drop of Loctite
removable thread locker.
RUBBER BUSHINGS REPLACEMENT
To remove the bushings use a small screwdriver and
spray soap.
Lubricate the bushings prior to installation. Install # 27
bushing at this end.
– 10 –