Specifications - Pearl Abrasive MPS100 Manual Del Propietario - Operador

IF YOU WISH TO USE THE TOOL WITH THE HANDLE,
PROCEED AS FOLLOW:
1) Assemble the appropriate blade to the tool. (See
instructions pg. 6)
2) With the tool lying flat on the floor, tilt the handle
forward and hook the handle bar to the under side
of the upper horizontal hand holding bar.
3) Unscrew the plastic knob located at the back of
the tool.
4) Tilt the handle backward until the holding
down bolt exceeds the slot provided at the
bottom part of the handle.
5) Screw the plastic knob on the holding
down bolt.
6) Connect the electrical cable of the
handle to the plug of the lower section.
Plug in the handle cable to the wall
electrical outlet or to an extension.
8) Activate trigger switch # 54.
iii. SPECIFICATIONS
SCRAPING NO LOAD
WIDTH SPEED
5 inch and 5800 RPM
9 inch
MPS100 MULTI-PURPOSE SCRAPER
OVERALL
LENGTH
14-1/2 inch
*NET POWER
WEIGHT SUPPLY
26 lbs. 120 volts
5 amps
60Hz
* Without handle
NOTES:
a) We reserve the right to change specifications without notice.
b) Specifications may vary depending on final destination.
NOTE: Specifications may differ from country to
country.
– 5 –
TRIGGER SWITCH
#54
VIBRATIONS
DB
LEVEL
60 2.5