Pearl Abrasive MPS100 Manual Del Propietario - Operador página 7

Blade Selection Table
BLADE SIZE
9"
5"
4" x 5-1/2"
4" x 8-1/2"
Side
FOR VINYL
TILES, CARPET &
FOAM OR
CUSHION FLOOR
To remove foam
back or cushion
floor use 9" blade
assembly (part # 9-15-11- 13 ). Always move the tool
with the blade edge flush with the surface to be scraped.
The speed and depth of cut will determine the finish
quality.
FOR HARD
FLOOR
To remove com-
mercial covering
and floor use 5" x
4" blade assembly
(part # 33-31).
Always move the
tool with the blade edge flush with the surface to be
scraped. The speed and depth of cut will determine the
finish quality.
If the material is too hard, remove part # 15
FOR VINYL AND
CORLON FLOOR
To remove vinyl
and Corlon floor
use the 5" blade
assembly ( part #
12-14-15). Always
move the tool with
the blade edge flush with the surface to be scraped. The
speed and depth of cut will determine the finish quality.
CUSHION CARPET
UNDER PADDING
FOAM JUTE
 
 
----- -----
----- -----
 
– 7 –
VINYL TILES PARQUETRY GLUE

-----



-----
----- 

-----
How to Scrape
Rest the blade edge on the surface to be removed;
linoleum, tile, foam, etc.. Tilt the tool forward, press the
trigger switch, advancing the tool to remove the material.
Each section or row of material will have a width of 6 to
9" depending on the blade size used.
Scraping will be easier if you angle the tool at the correct
angle and progress as per the tool performance. The
results obtained will help you determine the best
operation angle. Move forward as fast as the tool action
allows.
To scrape the floor of large rooms, such as; kitchens,
living rooms, bedrooms, dining rooms etc. Use the 9"
wide blade. For stairs or restricted floors such as
cupboards, wardrobes, etc. Use the 5" blade.
To start the tool with
the long handle,
simply pull the
trigger. Release the
trigger to stop.
TRIGGER SWITCH
To start the tool without the
long handle, simply move the
switch to ON or OFF.
TOGGLE SWITCH
NOTE: The switch and other electrical part
specifications may differ from country to country.
CAUTION: Before plugging-in the tool, always check the
trigger switch. It should return to the OFF position when
released. The same verification applies to the switch.

-----

-----




-----
-----