Tabla de contenido

Publicidad

Assemble a 1" long spacer (R) and the middle brace
(3) onto the long end of the shaft with the bent end of
the brace facing the wheel bracket. Next, add a 3.70"
long spacer (Q), a single spool assembly, a 1.33" long
spacer (S), a double spool assembly, a 1.33" long
spacer (S) and a 3/4" flat washer (N) onto the long
end of the shaft. See figure 4.
WHEEL
BRACKET (2)
MIDDLE
BRACE (3)
1" LONG
SPACER (R)
SINGLE SPOOL
ASSEMBLY (9)
DOUBLE SPOOL
ASSEMBLY (11)
FIGURE 4
Assemble the end plates (6) to the ends of the tray
(1) using four 5/16" x 3/4" hex bolts (E) and four 5/16"
nylock nuts (J) for each end plate. Do not tighten until
step 8. See figure 5.
5/16" x 3/4"
HEX BOLT (E)
5/16" NYLOCK
NUT (J)
END PLATE (6)
FIGURE 5
3.70" LONG
SPACER (Q)
1.33" LONG
SPACER (S)
1.33" LONG
SPACER (S)
3/4" FLAT
WASHER (N)

REAR VIEW

TRAY (1)
ENGLISH
Assemble the tongue to the tray using two 3/8" x 1"
hex bolts (D) and 3/8" nylock nuts (I) as shown in
figure 6. Tighten.
RIGHT SIDE
LEFT SIDE
FIGURE 6
Assemble the tongue using four 3/8" x 1-1/4" hex
bolts (C), four 3/8" whizloc nuts (P), and four 1/4"
nylock nuts (I). Tighten. See figure 7.
3/8" x 1-1/4"
HEX BOLT (C)
3/8"WHIZLOC
NUT (P)
RIGHT SIDE
LEFT SIDE
FIGURE 7
7
3/8" x 1"
HEX BOLT (D)
3/8" NYLOCK
NUT (I)
3/8" NYLOCK
NUT (I)

Publicidad

Tabla de contenido
loading

Tabla de contenido