Agri-Fab 45-05183 Manual De Instrucciones página 8

• Turn the tray upside down.
• Standing behind the tray, place the long end of the
shaft through the end plate on your right as shown in
figure 8. Place the other end of the shaft through the
end plate on your left. Make sure the bent end of the
middle brace rests flat inside the tongue (5). Make
sure the end plate on your left is perpendicular to
the tray, and tighten the bolts and nuts that attach
the end plate to the tray.
• Assemble a 3/4" flat washer (N) and a wheel bracket
(2) onto each end of the shaft. Turn each wheel
bracket to point in the direction shown below. Secure
each wheel bracket with a 1/4" x 1-3/4" hex bolt (B)
and 1/4" nylock nut (K). Tighten. See figure 8.
NOTE: If there is not enough room for the wheel bracket
on the end of the shaft, leave off the 3/4" flat washer(s).
TIGHTEN
FIGURE 8
• Assemble a wheel to a wheel bracket as shown in
figure 8. Use a 1/2" x 3-1/2" hex bolt (A), two 1/2"
washers (T), one 1/2" hex jam nut (L), and one 1/2"
nylock jam nut (H). Adjust the nuts so that the wheel
is held securely with minimum end play but will spin
freely. Repeat on other side. See figure 9.
1/2" WASHER (T)
FIGURE 9
WHEEL
BRACKET
HEX BOLT (B)
1/4" x 1-3/4"
WHEEL
BRACKET
3/4" FLAT
WASHER (N)
1/4" NYLOCK
NUT (K)
1/2" NYLOCK
JAM NUT (H)
1/2" JAM NUT (L)
1/2" x 3-1/2"
HEX BOLT (A)
1/2"
WASHER (T)
ENGLISH
• Assemble the hitch bracket to the tongue using two
3/8" x 1" hex bolts (D), and two 3/8" nylock nuts (I).
Tighten. See figure 10.
• Assemble the hitch pin (G) through the hitch bracket
and the tongue. Secure the hitch pin with the large
hairpin cotter (F). See figure 10.
HITCH
PIN (G)
HITCH
BRACKET
FIGURE 10
• Tip the aerator back and rotate the middle brace up
against the bottom of the tongue. Fasten it to the set
of holes shown using two 3/8" x 1" hex bolts (D) and
3/8" nylock nuts (I). Do not tighten until final step. See
figure 11.
MIDDLE
BRACE
(3)
FIGURE 11
8
3/8" x 1"
HEX BOLT (D)
3/8" NYLOCK NUT (I)
LARGE HAIRPIN
COTTER (F)
MIDDLE
BRACE (3)