Agri-Fab 45-05183 Manual De Instrucciones página 9

• Turn the lift handle as shown in figure 12 and attach it
to the side of the wheel bracket that is indicated. Use
a shoulder spacer (M), two 3/8" x 1-1/4" hex bolts
(C) and two 3/8" nylock nuts (I) to attach the wheel
bracket to the lift lever. Tighten the bolts and nuts.
See figure 12. Please note this is a difficult step.
• Push the grip (V) onto the lift handle. See figure 12.
3/8" x 1-1/4"
HEX BOLT (C)
3/8" x 1-1/4"
HEX BOLT (C)
FIGURE 12
ENGLISH
GRIP (V)
WHEEL BRACKET
SHOULDER
SPACER (M)
3/8" NYLOCK
NUT (I)
• Perform the following steps in sequence to tighten the
bolts and nuts that remain loose. Refer to figure 13.
a. Turn the aerator upright, then lock the lift handle
into the transport position.
b. Tighten the four bolts at the left corners of the
tray.
c. Tighten the two bolts which fasten the middle
brace to the bottom of the tray.
d. Tighten all hardware
c
FIGURE 13
9
b
b