red lion RLMPTC Manual Del Propietário

OWNER'S MANUAL
RLMPTC Portable Transfer Pump
The RLMPTC portable utility transfer pump is intended for intermittent duty, moving water from one location to
another. The pump can be used to move water from flooded basements, watering lawns and gardens, and drain-
ing water heaters. It can also be used to boost water pressure for washing vehicles, sidewalks, and decks.
Do NOT use this pump for:
• Submersible applications—submersion will immediately damage the pump
• Transferring potable water
• Effluent or sewage applications
• As a pond pump, or for pumping seawater
• Water hotter than 77°F (25°C)
• Locations classified as hazardous according to the National Electrical
Code (ANSI/NFPA)
The pump motor is equipped with an automatic resetting thermal protector, and may
restart unexpectedly. Thermal Protector tripping is an indication of motor overloading or
overheating. This can be caused by application issues such as an obstructed pump impeller,
pump running dry, excessively high or low voltage supply, or possibly a pump, motor,
bearing, or seal that has reached the end of its useful life.
Please examine your pump carefully to ensure that no damage occurred during shipment. If damage has
occurred, please contact the place of purchase. They will assist you in replacement or repair, if required.
This product is covered by a Limited Warranty for a period of 12 months from the date of original purchase by the
consumer. For complete warranty information, refer to www.redlionproducts.com; or, call Technical Support for a
printed copy.
Specifications
Model Phase
RLMPTC 1
BEFORE GETTING STARTED
This equipment should be installed and serviced by technically
qualified personnel who are familiar with the correct selection
and use of appropriate tools, equipment, and procedures. Failure
to comply with national and local electrical and plumbing codes
and within Red Lion recommendations may result in electrical
shock or fire hazard, unsatisfactory performance, or equipment
failure.
Know the product's application, limitations, and potential haz-
ards. Read and follow instructions carefully to avoid injury and
property damage. Do not disassemble or repair unit unless
described in this manual.
Refer to product data plate(s) for additional precautions, operat-
ing instructions and specifications.
Failure to follow installation or operation procedures and all
applicable codes may result in the following hazards:
Volts Hz Amps
115 60 10
Breaker Size Watts
15 A 1020
Risk of death, personal injury, or
property damage due to explosion, fire,
or electric shock.
• Do not use to pump flammable or explosive fluids such as
gasoline, fuel oil, kerosene, etc.
• Do not use in explosive atmospheres or hazardous locations
as classified by the NEC, ANSI/NFPA70.
• Do not handle a pump or pump motor with wet hands or
when standing on a wet or damp surface, or in water until the
unit is unplugged or electrically disconnected.
• If the power disconnect is out of sight, lock it in the open
position and tag it to prevent unexpected application of
power.
• Do not submerge motor or mount pump in a location where
motor will come in contact with water. This pump is not
designed for use in showers, hot tubs, spas or other poten-
tially wet locations.
EN
HP Shut Off
1/2 145 ft (44 m)
English