CASUALPLAY WAVE Manual De Instrucciones página 19

• Place the backrest in the required reclining position.
• Lastly, pull the harness adjustment strap until it fits the child correctly.
(fig.12)
REmOVING THE SAfETy SEAT
• Unfasten the harness buckle, by pressing the red button in the middle
of the buckle.
• Take the child out of the restraint system and fasten the buckle again.
• Unfasten the seat belt buckle and take the belt out of the guides and the
locking clip (lock off).
• Take the seat out of the vehicle.
INSTALLING THE SAFETY SEAT IN THE VEHICLE USING THE
THREE-POINT SEAT BELT (GROUP 2, 15-25 KG)
• Take the safety harness off. Consult the section below.
• Place the safety seat on the vehicle seat, press the child restraint
system, leaning against the front of it, against the vehicle seat (fig.7).
• Place the child in the restraint system.
• Take hold of the end of the vehicle seat belt, and pass the abdominal
under the armrests of the safety seat (fig.13).
• The diagonal part of the belt should go through the belt guide on the
headrest (fig.14).
• Fasten the seat belt and make sure that the seat is secure (fig.15).
REmOVING THE SAfETy SEAT
• Unfasten the vehicle seat belt buckle and take it out of the guides on the
safety seat.
• Take the child out of the restraint system.
• Lastly, take the safety seat off the vehicle seat.
REMOVING THE SAFETY HARNESS
• Loosen the safety harness (fig.1).
• Find the distribution plate, situated on the backrest, and remove the
chest straps of the harness (fig.16). Pass them through the slots in the
backrest and take the chest pads off (fig.17).
• Unfasten the safety harness buckle and extract the crotch strap buckle,
passing the metal part through the slot in the upholstery and the frame
(fig.18).
17