Kohler K-475 Guia De Instalacion página 11

Wall Plate
[A]
Setscrews
[B]
7. Install the Towel Bar
For [A] Length Bonnets
Partially thread the setscrew into each bonnet.
NOTE: The escutcheon sits loosely until the bonnet is in place and
the setscrew is tightened.
Slide the escutcheon onto the wall plate, if applicable.
Align the towel bar assembly over the wall plate.
Tighten the setscrew with a hex wrench.
For [B] Length Bonnets
IMPORTANT! Do not overtighten the setscrews. Overtightening can
damage the towel bar.
Use a hex wrench to thread a setscrew into each of the cylinder
heads and tighten. The detent on both cylinder heads should face
straight down.
Insert a cylinder head into each bonnet.
Insert a setscrew into both bonnets with a hex wrench. Tighten
the setscrews until the cylinder heads are secure against the
bonnets.
Kohler Co.
Shaft
Stately Bonnet
Setscrews
11
Classic Bonnet
Cylinder
Head
Towel Bar
1020823-2-D