Heater Config; Coil Type Registers (Read/Write); Discrete Input Type Registers (Read) Information On Heater - Astralpool 65321 Manual Del Usuario

9.5.

HEATER CONFIG; COIL TYPE REGISTERS (READ/WRITE)

These registers are oriented to a bit data type. Heater will only use these to activate some settings.
They are equivalent to the corresponding bits of holding registers types.
Name Address
0x120
Temperature scale
0x201
Overheat alarm
0x203
Flow not present
0x20E
Freezing risk
0x211
Temperature scale
0x218
Manual On / Off
9.6.

DISCRETE INPUT TYPE REGISTERS (READ) INFORMATION ON HEATER

Name Address
Alarm 0x000
Temperature scale 0x001
Manual On / Off 0x008
Overheated 0x011
Flow switch 0x013
Freezing risk 0x01E
0x020
Flow switch
Heating element 0x021
#1#
Heating element 0x022
#2#
Heating element 0x023
#3#
© ASTRALPOOL 2016 ALL RIGHTS RESERVED. PROPRIETARY DOCUMENT
Initial
Information
value
1 1 = °C
0 = °F
1 Allows writing a 0 to reset the overheating alarm
memory. If we try to write a 1 it returns a type 2
exception.
1 Allows writing a 0 to reset the flow needed and not
present alarm memory. If we try to write a 1 it returns a
type 2 exception.
0 Allows writing a 0 to reset the freezing risk alarm
memory. If we try to write a 1 it returns a type 2
exception.
0 1 = °C
0 = °F
1 1: Turns heater on
0: Turns heater off
Exception code 04 when writing with function 0x05 &
0x06
Initial
Information
value
0 0: No alarms.
1: There is an active alarm.
1 1: °C
0: °F
0 1: Heater on
0: Heater off
0 1: Overheated. Tin or Tout > 55 °C
0: Not overheated
0 0: Flow not needed.
1: Flow not present and needed.
0 1: Freezing risk present
0: No freezing risk
0 1: flow detected
0: flow not detected
0 1: Heating element #1# on
0: Heating element #1# off
0 1: Heating element #2# on
0: Heating element #2# off
0 1: Heating element #3# on
0: Heating element #3# off
.
22