Push Video Configuration - Velleman DVR16H3 Guía Rápida

12.

Push Video Configuration

12.1 Pin Connection
This DVR can send notifications to your mobile devices, such as iPhone
event occurs (push video). However, only certain alarm-in pins support this function.
There are several methods to connect alarm sensors for push video:
 via the push video alarm-in terminal
 via the external I/O port.
Push Video Alarm-In Terminal
A push video alarm-in terminal is provided on the DVR rear panel. Refer to the table below for the pin connections that
support push video and their corresponding video channels.
Alarm
Alarm 1
Alarm 2
Alarm 3
Alarm 4
External I/O port
Refer to the table below for the pin connections that support push video and their corresponding video channels.
Pin
Pin 2
Pin 15
Pin 3
Pin 16
Alarm sensor connection
Connect the alarm sensor, such as magnetic contacts, to the push video alarm-in terminal or I/O pins that support push video
on the DVR rear panel.
12.2 Configuration
Before configuring push video, make sure that:
 The DVR system is set up as described in Connection and Setup.
 The DVR is connected to internet.
 You have installed the EagleEyes app on your iPhone
For details, please refer to Mobile Surveillance via EagleEyes.
V. 01 – 25/09/2014
DVR16H3
Corresponding video channel
CH1
CH2
CH3
CH4
Corresponding video channel
CH1
CH2
CH3
CH4
® , iPad ® or Android
10
® , iPad ® and Android ® mobile devices, if an alarm
® mobile devices.
©Velleman nv