Ruwido Easytip Z1 Manual De Funcionamiento página 6

U s e r M a n u a l
Quick Set-up Reference
Insert batteries (checking correct polarity)
Step 1
Switch on the TV (fully on with a broadcast picture
Step 2
on the screen)
Press and hold the (F) key until the LED flashes
Step 3
twice in quick succession. (approx 2 seconds)
After the two flashes, remove your finger from the
Step 4
(F) key and within 5 seconds input the correct code
from the manual.
After you have input the code, wait for the LED to
Step 5
flash twice, this confirms that the number you
selected has been installed into the unit correctly.
Once the code has been installed, press the
Step 6
(ON/OFF) key on the controller. If the TV responds
by going into standby mode then continue to try
all the other functions. If some functions do not
work correctly then move to the next code in the
list repeating from step 3.
What to do if the TV does not respond
• Either the 4-digit code, or part of the programming
sequence was not completed within 5 seconds or the
code was not recognised. Please re-check the 4-digit
code in the manual or move onto the next code in the list
against your particular brand. Also ensure that the codes
entered are from the correct section of the manual.
6
Helpline 00800 31133113