Klarstein PASSIONATA ROSSA 20 Manual Del Usuario página 21

Cafetera espresso
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Note: In choosing the size of jug, it is recommended the diameter is not less than
70±5 mm, and bear in mind that the milk increases in volume by 2 times, make sure the
height of jug is enough.
4. Insert the plastic sleeve into the milk about two centimetres, then turn the coffee/
steam knob to the
in the way moving vessel round from up to down.
Caution: Danger of scalding
Be sure to operate carefully as the steam may result in scald to person.
After the brewing coffee, switch the rod to the middle for 10 second to
release the pressure before removing the funnel.
5. When the required purpose is reached, you can turn the coffee/steam knob to the
position (see fi g.2).
Note: Clean steam outlet with wet sponge immediately after steam stops generating, but
care not to hurt!
6. Pour the frothed milk into the espresso prepared, now he cappuccino is ready.
Sweeten to taste and if desired, sprinkle the froth with a little cocoa powder.
7.
Press and release the ON/OFF button to the higher position which is the "O FF"
position to cut off the power source.
Producing steam to heat liquids or froth milk singly
The steam wand can be used to froth milk singly or make hot beverages like drinking
chocolate, water or tea.
Method:
1. Remove the detachable tank and fi ll it with desired water. The water level must
not exceed the "MAX" mark in the tank. Then place the tank into the appliance
properly.
2. Then connect the appliance to power supply source.
3. Press down the ON/OFF button to the lower position which is the ON position, the
red indicator is illuminated.
4. Turning the coffee/steam knob to the  position and waiting for a moment, the
appliance begins to be heated until the green indicator is illuminated, it shows the
heating is fi nished.
5. Dip the steam wand with plastic sleeve into the liquid to be heated or the intended
froth milk. Turn the coffee/steam knob to the
6. When the required temperature is reached or the frothing milk is obtained, you can
turn the coffee/steam knob to the  position.
7.
Press and release the ON/OFF button to the higher position which is the OFF
position to cut off the power source.
position, steam will come out from the steam outlet. Froth milk
position and start making steam.
EN
21

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido