Installing Drain Spud In Bowl; Connect Supply Stops, Sprayhead Supply Tubing And P-Trap - Bradley TDB3103 Manual Del Usuario

Fuente de lavado semicircular con palangana profunda terreon de 914 mm (36") con control infrarrojo
Ocultar thumbs Ver también para TDB3103:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
3

Installing Drain Spud in Bowl

A
Secure drain spud with lock nut and washers.
Drain Pre-Pack
(S45-273)
4

Connect Supply Stops, Sprayhead Supply Tubing and P-Trap

A
Connect supply stops onto stub-outs.
Using a sharp knife, cut tubing squarely and
B
remove any burrs. Do not pinch or crush end
of tubing.
Loosen nut on fitting. Moisten end of tube
C
and push into fitting until it is firmly seated.
Tighten nut to secure tube to fitting (make
sure nut is securely tightened).
If connector leaks, reseat tubing. If leaking
D
persists, replace the male connector, or call
your bradley representative for assistance.
E
Connect p-trap (supplied by installer) to
tailpiece and drain outlet.
Bradley • 215-1332 Rev. V; ECN 12-00-004
Bowl
Seal between drain spud and drain hole with
plumber's putty (supplied by installer).
Strainer and Spud
Apply Plumber's Putty Here
Fiber Washer
Locknut
Flush supply lines before making connections.
Do not use pipe sealant on compression fittings.
Sprayhead
Tubing
TDB3104, WF3204
Male 3/8"
Connector
(145-105)
Nut
1/15/2013
Tube
Tubing
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wf3203

Tabla de contenido