Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Open the cover carefully: steam pouring out from the
tank could cause burns.
Always keep the unit's cover closed while polymeri-
sation programs are running.
Never place more than 9 muffles on the polymerising
tray.
Always keep at least 20 cm of water in the bottom of
the tank, as the heating elements may be damaged if
the level is lower.
Always leave a gap of at least 15 cm between the
unit's ventilation grille and the nearest wall or other
object.
Before plugging in the unit, fill the tank with water to
10 cm below the cover.
TALLERES MESTRAITUA, S.L. recommends po-
lymerising at around 95 ºC. At higher temperatures
too much steam may be generated.
CARACTERÍSTICAS TÉCNICAS
Height:
450 mm
Width:
635 mm
Depth:
405 mm
Weight:
34 kg
Power supply:
230 V, 50/60 Hz
Consuption:
2200 + 400 W
English
11
Publicidad
Tabla de contenido
