Speedaire 6Z899B Manual De Instrucciones Y Lista De Piezas página 2

Speedaire Operating Instructions and Repair Parts List
Speedaire
General Safety Information
(Continued)
10. Never point a spray gun at yourself
or at any other person. Accidental
discharge may result in serious injury.
E
11. Check hoses for weak or worn
N
condition before each use, making
G
certain that all connections are
L
secure.
I
12. Always shut off air pressure at
S
source and bleed off all pressure in
H
paint tank by gently pulling safety
valve ring before loosening knobs.
13. Regularly check to be sure gauge
and regulator are functioning
correctly. Also check that no paint
or other deposits are in the safety
valve inlet. In the event more than
50 psi is applied to the tank and the
safety valve is clogged, the higher
pressure could damage the tank or
result in injury.
Do not
spray
flammable materials in
vicinity of open flame or near
ignition sources including the
compressor unit.
14. Do not smoke when spraying paint,
insecticides, or other flammable
substances.
15. Use a face mask/
respirator when spraying
and spray in a well
ventilated area to
prevent health and fire hazards.
16. Do not direct paint or other sprayed
material at the compressor. Locate
compressor as far away from the
spraying area as possible to minimize
overspray accumulation on the
compressor.
17. When spraying or cleaning with
solvents or toxic chemicals, follow
the instructions provided by the
chemical manufacturer.
Paint Tank
®
Failure to follow
instructions on
proper assembly and use of a paint tank
may possibly result in damage to
property or personal injury. This unit
must be assembled as indicated in these
instructions. Only parts supplied with
this unit should be used. These parts are
safety performance engineered. Use only
OEM replacement components.
Assembly
NOTE: Use PTFE thread sealant tape or
thread sealant on all connections.
1. Assemble the regulator to the paint
tank lid as shown in Figure 1:
Pressure gauge
Pipe nipple
Figure 1
a. With arrow pointed down and
knob toward you, place the gauge
in the left 1/8 NPT regulator port.
b. Assemble the 1/8 plug into
opposite 1/8 NPT regulator port.
c. Thread the 1/4 T-fitting into the
top 1/4 in. regulator port.
d. Thread 1/4 in. pipe nipple into
bottom 1/4 in. regulator port (with
arrow).
e. Thread this assembly into the #3
1/4 NPT port on tank lid.
NOTE: This regulator is a special
pressure limiting regulator. Do not use
any other type of regulator with this
paint tank. Assemble the regulator to
the paint tank only as instructed.
2. Assemble the safety relief valve to
the tank lid port #4.
2
Handle
Safety
relief
valve
Material tube
Figure 2
3. Install the pipe plug into the 1/8
NPT port #2 of the tank lid.
4. Thread the handle into the center
port of the tank lid.
5. Install hose connector in tank lid
port #1 from the top.
6. The material tube is pre-assembled
to port #1.
7. To assemble tank bracket with knob
assembly:
a. Lay out tank bracket to form
circle (4 sections).
b. Insert eyebolt between each
section, slip hex bolt through
holes and loosely screw on stop
nuts.
c. Flip tank upside down and slip
bolted bracket assembly around
tank.
d. Slide bracket down to rim and
tighten all nuts.
6Z899B
Hose
connector
Pipe plug