Speedaire 6Z899B Manual De Instrucciones Y Lista De Piezas página 3

Speedaire Operating Instructions and Repair Parts List
Model 6Z899B
Assembly (Continued)
EQUIPMENT USE
TO USE A SPRAY GUN
1. Attach the air supply hose (not
Included) to the 1/4 NPT T F
Air OUT to
spray gun
(unregulated)
Air
IN
Hose connectors
Figure 3
2. Attach an air hose between the
opposite side of the T Fitting and the
spray gun air inlet.
NOTE: A 15 foot air hose and 15 foot
material hose between the paint tank
and spray gun is recommended. Up to 25
feet of air hose may be used between
the paint tank and the compressor. A
longer length may create a large
pressure drop.
Material
hose
Pressure
gauge
Paint tank
regulator
Knob
Figure 4
3. Attach a material hose between the
paint tank connection and the spray
gun material inlet.
Operation
1. Before using the tank for the first
time, the seal and bracket position
should be established by pre-
pressurizing the tank.
a. Connect the material hose to the
spray gun.
b. Connect the air hose from
regulator to the spray gun or cap.
c. Before filling the tank with paint
material, evenly tighten the
knobs so that the lid is secure and
sealed.
d. Close the paint tank regulator by
turning fully counterclockwise,
then open the air regulator on
the source to deliver air to the
paint tank regulator.
Air hose
Material hose
Air hose
e. Increase paint tank pressure by
turning the knob clockwise until
30 psi reads on the tank regulator
gauge.
f. Check for leaks in the system. If a
fitting leaks, depressurize the
tank by shutting off the air at the
air source regulator and gently
pulling the ring on the paint tank
safety valve until air no longer
hisses from it. Tighten the leaking
fitting, then open the air source
regulator to deliver 30 psi into the
paint tank and material hose.
g. Depressurize system by shutting
off air supply, then gently pull the
relief valve ring to relieve the
pressure in the system.
2. The tank may now be filled with
material. Before filling, thoroughly
mix and strain the paint to remove
skins or undissolved particles which
might otherwise impede the flow of
material through the hose and gun.
A one gallon can of paint can be set
inside the tank instead of pouring
the paint into the tank.
which contain trichloroethane,
Air source
chlorinated hydrocarbons,
regulator
nitrohydrocarbons, esters, amines, or
organic compounds. These materials will
damage the gasket between the paint
tank and lid. A damaged gasket may
cause injury and will reduce the efficiency
of the paint tank.
3. Place lid on paint tank then tighten
knobs evenly and gradually.
DO NOT USE WRENCH OR PLIERS TO
TIGHTEN KNOBS. HAND TIGHTEN
ONLY (50 IN.LBS.)
4. Turn pressure off at the air source
regulator by turning counterclockwise.
Pressure gauge should read 0 psi.
5. Shut off paint tank regulator by
running counterclockwise.
3
E
N
G
L
I
S
H
Never use this paint
tank with materials
®