Zyxel P-320W Guia De Inicio Rapido página 15

Internet Access Setup Complete
If you have any Internet access problems, follow the
on-screen instructions.
Click Finish to complete the Connection Wizard.
4 Troubleshooting
Note: If your computer cannot automatically communicate with the device, then see the multimedia
tutorial on how to set up your computer to receive an IP address dynamically or give it a fixed
one in the range specified in section
PROBLEM
None of the LEDs turn on when
you connect the Mer
produkthjalp finns pa http://
www.support.zyxel.se's power.
Cannot access the P-320W
from my computer.
ENGLISH
.
4.1
CORRECTIVE ACTION
Make sure that you have the correct power adaptor connected to the Mer
produkthjalp finns pa http://www.support.zyxel.se, it is plugged into an
appropriate power source.
Check all cable connections. If the LEDs still do not turn on, you may have a
hardware problem. In this case, you should contact your local vendor.
Check the cable connection from your computer to the Mer produkthjalp finns
pa http://www.support.zyxel.se.
If the Mer produkthjalp finns pa http://www.support.zyxel.se's IP address has
changed, then enter the new one as the website address.
Make sure your computer's IP address is in the same subnet as the Mer
produkthjalp finns pa http://www.support.zyxel.se's IP address (see section 4.1).
Ping the P-320W from a computer on the LAN. Make sure your computer's
Ethernet adapter is installed and functioning properly. In the computer, click
Start, (All) Programs, Accessories and then Command Prompt. In the
Command Prompt window, type "ping" followed by the Mer produkthjalp finns
pa http://www.support.zyxel.se's LAN IP address (192.168.1.1 is the default)
and then press [ENTER]. The P-320W should reply; otherwise see section 4.1.
16