Troubleshooting Guide - Guardian Technologies H980W Instrucciones De Uso Y Cuidado

PROBLEM
Water vapor and humidity
are not produced.
Air blows but water vapor
is not produced.
Humidity level is low.
The humidity has
a bad smell.
White dust is forming on
nearby furniture.
Unit has stopped working.
Water is accumulating
outside of unit or area
surrounding unit.
Increased noise level.
Power button flashing red.
Cannot smell aroma scent.
TROUBLE SHOOTING GUIDE
SOLUTION
Power Plug: Unplug and then try again.
Power Failure: When the power is returned, try again.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
Excessive Water: Empty the water in the base of the unit.
Detergent residue and/or oil ingredients from cosmetics, eta may be in
tank; wash out tank and try again.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
If you use hard water, replace with softer water.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
The water in the unit is too cold: Replace with cool, but not cold water.
Damage on the ultrasonic disk: Contact Customer Service
Poor maintenance or dirty water: Clean the product thoroughly,
and fill it with fresh water.
Hard water may deposit a certain amount of dust. Dust in the air also
settles because of added humidity in the room. Use distilled water if
this becomes a nuisance.
No or low water. Unplug unit and refill tank.
Saturation of humidity. Lower mist control setting.
Unit not level and water is accumulating. Unplug and place on level
surface. Point spray away from objects. Raise unit on a water-resistant
level surface 2-3 feet off of floor.
Unit must be placed on a flat, level, hard surface.
Make sure it is NOT placed on a soft or absorbent surface.
Indicates low water. Unplug and refill tank.
Add a few more drops of oil to the aroma
pad or replace aroma pad with a new one.
E-7