Connect The Wiring - NuTone 788CHNT Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4. Place housing in
opening so that
its bottom edge is
flush with finished
ceiling. Screw
housing to joist
through holes in
housing as shown.
5. Seal between
ceiling material and
housing to prevent
air leakage.
INSTALL THE DUCTWORK
NOTE: The duct connector has a counter-balanced damper
flap. The flap will be "open" approx. 1" when duct connector
is attached to housing. This design permits insulation to be
in direct contact with fan/light housing per UL (Underwriters
Laboratories) standards. The slightest backdraft, however,
will close the damper flap, preventing air from entering unit
or finished space.
1. Connect 4" round
duct to damper/
duct connector
and extend duct
to outside through
a roof or wall cap.
Check damper to
make sure that it
opens freely. Tape
all duct connections to make them secure and air tight.

CONNECT THE WIRING

SCHEMATIC WIRING DIAGRAM
L I G H T
S W I T C H
V E N T
S W I T C H
B L K
L I N E
W H T
I N
G R D
S W I T C H B O X
BLACK
WHITE
BLUE
SWITCH BOX
LIGHT
FAN
DUAL CONTROL
(purchase separately)
120 VAC LINE IN
1. Wire unit as shown. Re-install wiring plate removed in
Step 2 under "PREPARE THE HOUSING" .
2. Run electrical cable as direct as possible to unit. Do not
allow cable to touch sides or top of unit after installation
is complete.
SEAL BETWEEN CEILING
MATERIAL & HOUSING
MOUNTING SCREWS
R E D
B L U
W H T
L I G H T
( W H I T E )
B L K
B L K
W H T
V E N T
( B L A C K )
W H T
G R D
U N I T
RED
BLACK
GROUND
RECEPTACLE
(bare)
(FAN)
WHITE
RECEPTACLE
(LIGHT)
FINISH THE INSTALLATION
1. Re-install blower
assembly removed
in Step 1 under
"PREPARE THE
HOUSING" . Plug blower
into black receptacle.
3. Locate grille pan
over fan housing and
connect light plug into
white receptacle in fan
housing.
4. Attach grille pan to
mounting brackets with
(2) screws (included).
5. Thread rod onto
threaded stud in center
of grille pan. Tighten rod
securely.
MODEL 788CHNT
Page 3
2. Attach grille pan
mounting brackets to
housing with screws
(included). Make sure
brackets face inward.
METAL
WASHER
FELT
WASHERS
FELT
WASHER
6. Install bulbs. Use 13-
watt (maximum), GU24
type, fluorescent bulbs.
7. Place washers and
glass shade over
mounting rod and align
shade over grille pan.
Secure shade to grille
pan with washer and
finial nut as shown.
8. Restore electrical
power and check
operation of the unit.

Publicidad

Tabla de contenido
loading

Tabla de contenido