Connect The Wiring - NuTone 745BNNT Manual De Instrucciones

Ventilador decorativa con la luz
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALL THE DUCTWORK
NOTE: The duct connector has a counter-balanced damper
flap. The flap will be "open" approx. 1" when duct connector
is attached to housing. This design permits insulation to be
in direct contact with fan/light housing per UL (Underwriters
Laboratories) standards. The slightest backdraft, however,
will close the damper flap, preventing air from entering unit
or finished space.
1. Snap the damper/duct connector onto housing. Make sure
that tabs on the connector lock into slots in housing. Top of
damper/duct connector should be flush with top of housing.
2. Connect 4" round duct to damper/duct connector and
extend duct to outside through a roof or wall cap. Check
damper to make sure that it opens freely. Tape all duct
connections to make them secure and air tight.

CONNECT THE WIRING

SCHEMATIC WIRING DIAGRAM
L I G H T
S W I T C H
V E N T
S W I T C H
B L K
L I N E
W H T
I N
G R D
S W I T C H B O X
BLACK
WHITE
BLUE
DUAL CONTROL
(purchase separately)
SWITCH BOX
LIGHT
FAN
120 VAC
LINE IN
1. Wire unit following diagram above. Run electrical cable as
direct as possible to unit. Do not allow cable to touch sides
or top of unit after installation is complete.
FLUSH
R E D
B L U
W H T
L I G H T
( W H I T E )
B L K
B L K
W H T
V E N T
( B L A C K )
W H T
G R D
U N I T
WHITE
RED
RECEPTACLE
(LIGHT)
GROUND
(bare)
WIRING
PLATE
ATTACH THE GRILLE PAN AND
GLASS SHADE
GLASS SHADE
GRILLE
PAN
GLASS
SHADE
FINIAL
BLACK
1. Locate the grille pan over the fan housing and connect the
RECEPTACLE
wiring harness plug into white receptacle in the fan housing.
(FAN)
2. Insert rod through center hole of grille pan. Use lock washer
between collar on rod and pan.
3. Thread rod onto grille screw in housing, until pan is tight
against ceiling. Do not over-tighten mounting rod.
4. Install bulbs. Use 60-watt (maximum), B10 type, candelabra
bulbs or energy-efficient equivalent bulbs with an M.O.L. of
4.8 inches or less.
5. Place washers and glass shade over mounting rod and align
shade over grille pan. Secure glass shade to mounting rod
with steel and felt washers and finial cap and nut as shown.
6. Restore electrical power and check operation of the unit.
GRILLE PAN
GRILLE SCREW
LOCK
WASHER
COLLAR
ROD
WASHERS
LOCK
WASHER
ROD
STEEL
WASHER
FELT
WASHER
(Add second
washer as
needed to
secure shade
tightly.)
FINIAL
CAP
NUT
MODEL 745BNNT
Page 3
60 WATT
MAX.
B10 TYPE
CANDELABRA
BULBS
(2 REQ.)

Publicidad

Tabla de contenido
loading

Tabla de contenido