Autec Battery Charger - AUtec MBC825A Manual De Usuario

A battery charger is a device used to recharge batteries used in Autec
radio remote controls.
It is generally used horizontally, but can also be placed vertically; in
this case it shall be fastened with hooks in the appropriate holes (see
drilling template on page 2).
Autec accepts no responsibility for any use that does not
comply with the limitations and indications contained in this
manual and for any damage that may result from improper,
incorrect or irrational use of the battery charger.
Plate
Technical, identification and approval data of Autec battery chargers
are given on their plates (see page 2).
Such plates must not be removed from their position.
Removal will invalidate the guarantee.
Position and initial checks
Always respect the following warnings before use:
Keep the battery charger far from liquids (water and similar),
damp and wet locations and heat sources.
Do not in any case perforate, modify or tamper with the bat-
tery charger.
Check that the contacts are intact and clean before inserting
the battery in its housing in the battery charger. If neces-
sary, clean them with a wet cloth and wipe them thoroughly.
Warnings for use
This equipment is not suitable for people (including chil-
dren) with reduced physical, sensory or mental capabilities,
or lack of experience, unless they are supervised and have
Page 18

AUTEC BATTERY CHARGER

LIMBS0U3-00_eng.fm