AUtec MBC825A Manual De Usuario página 26

To recharge a battery:
1.power on the battery charger (the POWER light switches on)
- if the supply cable cannot be unplugged, close the switch to pro-
vide power supply
- if the supply cable can be unplugged, connect the battery
charger to power supply
2.insert the battery in its proper housing in the battery charger.
The CHARGE light switched on indicates that recharging has start-
ed.
3.wait until the battery is completely charged (the CHARGE light
goes off)
4.remove the battery. If the battery is not removed at the end of the
recharging process, the charger switches to trickle charging.
5.disconnect the power supply from the battery charger (the
POWER light switches off).
Page 26 LIMBS0U3-00_eng.fm