Assembly - Craftsman 247.770990 Manual Del Operador

Fresh Start
Cartridge
Bottle of
Engine Oil
Operator's
Manual
Upper
Drive
Handle
Control
Rope
Guide
Wing
Nut
Upper
Hose
Handle
Bracket
Lower
Hose
Handle
Bracket
Figure 1
This unit is shipped without gasoline or
IMPORTANT:
oil in the engine. After assembly, see OPERATION
section of this manual for proper fuel and engine oil
fill-up.

ASSEMBLY

™
WEAR YOUR
Safety Glasses
Hose Assembly
Speed
Control Blower
Chute
Lower
Handle
Cable
Handle
Guide
Knobs
Carriage
Screws
Wing
Nuts
Bag
NOTE:
Reference to right and left hand side of the
Yard Vacuum is observed from the operating
position.
This Yard Vacuum has been completely assembled
at the factory, except for the handle, bag, and blower
chute. These parts are shipped loose in the carton.
A pair of safety glasses, the owner's manual, a bot-
tle of engine oil, and one FreshStart™ cartridge are
also included in the carton. See Figure 1.
OPENING CARTON
• Cut each corner of the carton vertically from top
to bottom.
• Remove all loose parts.
• Remove loose packing material.
REMOVING UNIT FROM CARTON
• Lift unit from the rear to detach it from underlying
carton material and roll unit out of carton.
• Check carton thoroughly for any other loose
parts.
NOTE:
Make sure not to crimp cables while
removing loose parts or the entire unit from the
carton.
LOOSE PARTS IN CARTON
• Upper and Lower Handle
• Hose Assembly
• Bag
• Blower Chute
• Safety Glasses
• A Bottle of Engine Oil (may be located in bag)
• Operator's Manual
• FreshStart™ Cartridge
DISCONNECTING SPARK PLUG
Before proceeding with assembly of your new Yard
Vacuum, disconnect the spark plug wire from the
spark plug and ground it onto the retaining post on
the engine. This will prevent accidental starting of
the engine. See Figure 2.
Retaining
Post
Disconnect and Ground to Post
6
(See Figure 1)
Spark
Plug Wire
Figure 2