Float/Cage Assembly - Craftsman 113.170660 El Manual Del Propietario

SP6570 16 gallon detach

Float/Cage Assembly

WARNING:
For your own safety,
never connect plug to power source
outlet until all assembly steps are com-
plete and you have read and under-
stood the safety and operation instruc-
tions. Do not operate vac with any
parts damaged or missing.
1. Remove the detachable blower from
the power head assembly by pressing
down on the power head latch
beneath the carry handle of the
detachable blower. Set the detachable
blower off to the side. Place lid upside
down on the drum.
2. Locate the float and filter cage.
3. Place the float over the opening in the
center of the lid with the words "This
Side Towards Lid" laying face down
over the hole. (See illustration.)
WARNING:
To avoid personal injury
or damage to vac be sure to keep
hands, fingers, or any other foreign
objects out of the center opening when
assembling the float .
4. Line up filter cage tabs, as shown,
with the slots in the center ring of the
lid assembly. Push on the filter cage
until the tabs snap into slots for a
secure fit.
NOTE: If filter cage needs to be
removed, or replaced, because the float
is placed in the wrong way, use a flat
blade screwdriver and insert the blade
near one of the tabs between the filter
cage and the center ring of the lid. Pry
the tab out of the slot. Tilt the cage and
lift away from the lid. To replace, follow
Float/Cage Assembly instructions.
12/8/04 8:47 AM Page 6
Carry Handle
Filter Cage
Tabs (3)
Solid End
THIS SIDE
TOWARD LID
6
Power Head
Assembly
Power Head
Latch
Float
Power
Assembly
Filter Cage
Slots (3)
Tabs (3)
Slots (3)