Safety Regulation When Using Bona Belt - Bona Belt Manual De Funcionamento

Safety Regulation when using Bona Belt

When using electrical machines basic safety regulations
should always be followed in order to reduce the risk of fire,
electrical accidents and personal injury. Therefore, read all of
1) For safer use
Keep the work area clean. A messy workplace increases the
risk of accidents.
2) Pay attention to the surroundings
Do not allow the machine to come into contact with water or
moisture. Do not use the machine near flammable fluids or gases.
3) Protect against electrical accidents.
Always use the earth fault breaker! Avoid contact with
unearthed objects or surfaces, such as wires, pipes, electric
ovens, refrigerators, etc.
4) Belt/safety belt
Use a belt/safety belt to maintain better control over the machine
at the same time as it provides relief for the back and arms.
5) Protective and drum covers
Never operate the machine without mounted and closed
protective and drum covers.
6) Keep unauthorized persons away from the work site
Do not allow unauthorized persons come into contact with
machines and power cables.
7) Storing the machine
When the machine is not in use it should be stored in a dry area,
preferably in a locked area.
8) Do not overstrain the machine
The machine works best when it is used according to its
capacity and design. Allow the motor to "rest" during periods of
heavier use. The motor will cool better, thus increasing its lifespan.
Use fuses with the correct ampere number in relation to the motor.
9) Use the correct machine
Do not allow a smaller machine or accessories do the work of a
larger machine. Never use a machine for anything other than its
intended use.
10) Use the correct clothing
Do not wear loosely fitting clothing as these can become stuck
in the machine.
11) Be careful with power cables
Always use the correct power cable and the correct power
cable length. (See the accessories list). Never carry the machine
20 20
Always use the earth fault breaker!
the instructions before the machine is used. Then save the
instructions!
by holding the power cable. Do not pull the power cable out
of the machine or the power socket. Protect the power cables
against heat, oil and sharp edges. Keep the power cable away
from the machine's grinding area.
12) Disconnect the machine when it is not in use
Ensure that the machine does not start unintentionally. Never
carry a connected machine with a hand on the switch. Ensure
that the switch is not on when the machine is connected to the
power socket. Never use the machine if the breaker does not
function as it should.
13) Remove service tools before starting the machine.
Check to ensure no tools are on the machine when starting or
running the machine.
14) Use personal safety equipment
Use a P2 face mask. Use approved ear protection.
15) Inspect the machine regularly
If broken parts are discovered these should be replaced
immediately. If needed, contact the manufacturer or a
manufacturer authorized distributor or service company.
Note! Usage of other accessories than what is recommended
can lead to the risk of personal injury and/or cause damage to
the machine.
16) Keep the machine in good working order
Keep the machine clean for better and safer use. Follow the
given instructions concerning lubrication and replacement of
accessories. Inspect the machine regularly. In the event of
damage, repair or replace the faulty parts. Keep the handle
clean and free from grease.
17) Emptying the dust bag after sanding
After sanding, the dust bag must be emptied completely and
the contents stored safely outdoors and in a safe place due to
fire hazard. Explosions may occur in certain concentrations of
sanding dust.
18) Be aware when you work
Use common sense. Never use the machine if you are tired,
have consumed alcohol or if you take medications that can
impair your sight, you judgment or motor control. Due to
sanding dust, smoking is not permitted when sanding.
Bona Belt Manual