Auping AVS 455 Manual De Instrucciones página 33

The mesh base fails to
respond to the infrared
remote control
The mesh base fails to
respond to the infrared
remote control
Infrared remote
control, lights blinking
The mesh base fails to
respond to the remote
control with cable
Hinge defect
_03PII_4473 BW.pdf - pag.31
All manuals and user guides at all-guides.com
Cause Search
Wrong infrared channel. Check that the switch
on the remote control
and the switch on the
control box are set to
the same channel.
The signal from the Check if the system
handset is not being works by pointing the
picked up by the handset directly at the
receiver in the control control unit beneath the
unit. The signal may fail bed. Check if the control
to reach the receiver if unit has been fixed
the handset is a properly.
substantial distance
from the control unit or
the latter is covered by
a duvet, for example.
Processor failure.
Cable failure Check cable at the
strain relief.
Transport failure.
LET OP !!! Lage resolutie!
Solution
If not: switch one of the
switches to the correct
channel.
Remove the duvet or
blankets that may be
interrupting the signal.
Install IR preamplifier if
necessary.
Reset. Take batteries
out, push some buttons.
Put batteries in again.
Replace
Replace mesh base.
GB31
November 12, 2009