Troubleshooting - Gigabyte T1000 Serie Manual De Usuario

4.1 Troubleshooting

•••••••••••••••••••••••
Warning: Under the condition that you can't handle trouble,
please refer to your dealer to get professional service.
AC Adapter
Trouble
Make sure the AC adapter is well connected to
the power source and T1000.
No power supplies
Check the cable and plug to make sure they
to T1000
are OK. If they are broken, please contact your
local dealer ASAP.
Battery Pack
Trouble
The remaining power in battery pack may be not
No power supplies
enough to power on the machine. Connect AC
to T1000
Adapter to recharge it.
Check temperature of battery pack's surface.
Battery pack can't be recharged if its tempera-
ture is too high or too low. Recharged it after
its temperature is the same with the normal
Can't be recharged environment one.
after connecting
If battery pack is fully discharged, it won't be re-
AC Adapter
charged at once. Please wait for some minutes.
If the power indicators of battery pack are
always not lit up, its life may be over. Please
contact your dealer to buy another one.
Solution
Solution
Battery life depends on using condition of
T1000. You can change the settings in Power
Manager of OS to save power.
Battery pack can't exert its full capacity if it
Battery life is not as
works when not fully recharged frequently.
long as it should be
Power T1000 by battery pack until its power
drops to a critically low level and the machine
emits a high-pitched beep or displays a warning
message; after that, recharge battery pack to
make battery pack work longer.
WARNING: Please pay attention to the following
information regarding the battery pack:
1.Be sure to recycle the waste batteries.
2.Do not place the batteries near high-temperature
locations, fire source or in burning fire as this may
cause the batteries to explode
3.Do not assemble/disassemble /modify the batteries
without authorization.
4.Use the battery pack provided by the original
manufacturer only. Batteries other than those supplied
by the original manufacturer may damage the device.
Keyboard
Trouble
Press character keys
but number displayed Check if Num Lock is activated.
instead of character
Make sure there is no software to config-
Confusing display
ure the keyboard.
T1000 SERIES USER'S MANUAL
Solution
21