Installing Adapter Brackets To Display - peerless-AV SUA746PU Instalación Y Montaje

Installing Adapter Brackets to Display

• Tighten screws so display brackets are fi rmly attached to display. Do not tighten with excessive force.
Overtightening can cause stress damage to screws, greatly reducing their holding power and possibly causing
screw heads to become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to display or product may fail.
To prevent scratching the display, set a cloth on a fl at, level surface that will support the weight of the display. Place
2
display face side down. If display has obstructions on the back, remove them to allow the adapter brackets to be
attached. Place adapter brackets (B) on back of display, align to holes, and center vertically on back of display as
shown below. Attach the adapter brackets to the back of the display using the appropriate combination of screws,
washers, and spacers, if required, as shown in steps 2-1 or 2-2.
NOTE: Top and bottom holes must always be used.
Verify that all holes are properly aligned, and then tighten screws using allen wrench (G).
NOTE: For fl at back displays proceed to step 2-1. For bump-out or recessed back display skip to step 2-2.
WARNING
B
CENTER BRACKETS
VERTICALLY
ON BACK OF
DISPLAY
NOTE: "X" dimensions should be equal.
6 of 29
X
NOTE: LATCHES
INDICATED BOTTOM
OF BRACKETS (B).
X
ISSUED: 10-24-11 SHEET #: 095-9364-1