peerless-AV EPT650 Instalación Y Montaje página 7

For Flat Back Display
Begin with the shortest length screw, hand thread through multi-washer and tilt bracket into display as shown
2-1
below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not over
tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Display
2-2
Begin with longer length screw, hand thread through multi-washer, tilt bracket and spacer in that order into display
as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
DISPLAY
DISPLAY
SPACER
7 of 26
fi g. 2.1
MULTI-WASHER
SCREW
TILT BRACKET
(B or C)
fi g. 2.2
MULTI-WASHER
SCREW
TILT BRACKET
(B or C)
ISSUED: 01-05-11 SHEET #: 203-9014-3 06-01-12