Service Parts - Broan QTR Serie Manual De Instrucciones

CONNECT WIRING
4. Connect electrical wiring.
Run 120 VAC house wiring to installation location. Use
proper UL approved connector to secure house wiring to
wiring plate. Connect wires as shown in wiring diagrams.

SERVICE PARTS

Key No. Part No.
1 97016466 Housing
2 97016449 Duct Connector-4"
3 98010102 Wiring Plate
4 99170245 Screw, #8-18 X .375
5 97018010 Wire Panel/Harness Assembly
6 97017782 Blower Assembly (QTR050F)
97017783 Blower Assembly (QTRE080)
97017854 Blower Assembly (QTRE110)
7 97016497 Grille Assembly
8 99140199 Grille Spring (2 req'd)
9 97018014 Spacer (2 supplied)
10 QTHB1 Hanger Bars (QTRE080, QTRE110)
11 99420665 Thumbscrew, #8-18 x .375
Order service parts by "Part No." - not by "Key No."
SERVICE NOTE To remove Blower Assembly: Unplug motor.
Remove thumbscrew (11) from motor plate flange. Find the
single TAB on the motor plate (located next to the receptacle).
Push up near motor plate tab while pushing out on side of
housing. Or insert a straight-blade screwdriver into slot in
housing (next to tab) and twist screwdriver.
Description
(includes key no. 8)
MODELS QTR050F • QTRE080 • QTRE110
INSTALL GRILLE
5. Finish ceiling.
Install ceiling material. Cut out around housing.
6. Attach grille
to housing.
Squeeze grille
springs and insert
them into slots
on each side of
housing.
7. Push grille
against
ceiling.
Replacement parts
can be ordered on our
website. Please visit
us at www.broan.com
Page 4
99044371B