Ice Storage Bin - GE TBM18JAC AA Manual Del Consumidor

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

About the ice dispenser.
On some models
Spill Shelf
To Use the Dispenser
Press the rim of the glass gently against the
dispenser pad.
Select ICE CUBES, CRUSHED ICE or WATER
(on some models).
The spill shelf is not self-draining. To
reduce water spotting, the shelf and its
grille should be cleaned regularly.

Ice Storage Bin

To remove:
Lift the front of the bin and pull the bin
straight out while supporting it at front
and rear.
To replace:
Slide it back on the ice bin shelf. If the bin
does not go all the way back, remove it and
rotate the drive mechanism 1/4 turn. Then
push the bin back again.
Water Filter Accessory
The water filter is an option at extra cost
and is available from your dealer. Specify
WR97X0214. It has complete installation
instructions and installs on 1/4" O.D.
copper water line.
Important Facts About Your Dispenser
Add ice before filling the glass with a
beverage. This will prevent splashing,
which could cause the ice selector switch
to stick or bind.
Do not add ice from trays or bags to
the storage bin. It may not crush or
dispense well.
Avoid overfilling glass with ice and use of
narrow or extra-tall glasses. Backed-up ice
can jam the chute or cause the door in the
chute to freeze shut. If ice is blocking the
chute, poke it through with a wooden spoon.
Beverages and foods should not be quick-
chilled in the ice storage bin. Cans, bottles
or food packages in the storage bin may
cause the icemaker or auger to jam.
If no water is dispensed when the refrigerator is
first installed, there may be air in the water line
system. Press the dispenser pad for at least two
minutes to remove trapped air from the water line
and to fill the water system. To flush out impurities
in the water line, throw away the first six glassfuls
of water.
CAUTION: Never put fingers or any other
objects into the ice crusher discharge opening.
Rotate
Drive
Mechanism
Some crushed ice may be dispensed even
though you selected ICE CUBES. This
happens occasionally when a few cubes
accidentally get directed to the crusher.
After crushed ice is dispensed, some
water may drip from the chute.
Sometimes a mound of snow will form on
the door in the ice chute. This condition
is normal and usually occurs when you
have dispensed crushed ice repeatedly.
The snow will eventually evaporate.
Dispensed water is not ice cold. For colder
water, add crushed ice or cubes before
dispensing water.
11

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Tbm18jac wwTbm18gad ww

Tabla de contenido