Kobalt A081002 Manual Del Usuario página 6

SAFETY INFORMATION
offs, etc., without properly adjusting the angle of the snow discharge. Keep children and pets
away from the work area.
• Do not operate the power tool at high speeds on slippery surfaces. Look behind when backing up
and exercise caution.
• Wear safety glasses or goggles that meet ANSI Z87.1 standards.
• Use the power tool in daylight or in good artificial light. Ensure lights are on if using in low light
conditions
• To avoid accidental start-ups, remain in the starting position when turning the power tool on. The
operator and the power tool must be in a stable position during start-up. See the section titled
Powering On and Off.
• Use this power tool only for the purposes it was designed.
• If the impeller does not rotate freely due to ice, thaw the power tool thoroughly before attempting
to use it.
• Keep the impeller clear of debris.
• Do not attempt to clear the impeller while the motor is running.
• After striking a foreign object, turn the power tool off and disconnect it from the power supply, then
inspect it for damage. Repair any damage before restarting and using the power tool.
• If the power tool starts to vibrate abnormally, stop the power tool immediately and attempt to
determine the cause. Vibration is generally an indication of danger.
• Stop the motor and disconnect it from the power supply whenever the operator is not in the
operating position, before unclogging the impeller, and before making any repairs, adjustments, or
inspections.
• Do not use on graveled surface unless the power tool is adjusted for such a surface in accordance
with the operator's manual.
• Keep Children Away – All visitors should be kept a safe distance from work area.
• Dress Properly – Do not wear loose clothing or jewelry. They can be caught in moving parts.
• Wear rubber boots when operating the power tool. Do not operate the equipment when barefoot
or wearing open sandals. Always wear substantial footwear.
• Operation of the power tool in the hand-held position is unsafe, except in accordance with the
special instructions for such use provided in the operator's manual.
• Keep guards in place and in working order.
• Don't Force Power Tool - it will perform better and safer at the rate for which it was designed.
• Don't Overreach – Keep proper footing and balance at all times.
• If the power tool strikes a foreign object, follow these steps:
i) Stop snow thrower. Release the switch.
ii) Unplug power cord.
iii) Inspect for damage.
iv) Repair any damage before restarting and operating the snow mover
• Store Idle Power Tool Indoors – When not in use, power tools should be stored indoors in a dry,
locked-up place out of reach of children.
• Maintain Power Tools With Care - Follow instructions for lubricating and changing accessories.
• Allow the power tool to run for a few minutes after clearing snow in order to prevent moving parts
from freezing.
• Only use identical replacement parts and accessories for this power tool. The use of nonidentical
parts or accessories could lead to serious injury to the user or damage the power tool, and will
void the warranty.
• Do not pick up the power tool while it is running. The power tool is designed to travel along the ground.
• Never allow children to operate a power tool. Keep the area of operation clear of all persons,
6