Integra MicroFrance CM201 Manual De Instrucciones página 37

6
7
8
9
10
11
NT001
O – 2015/11
Insert the cannula into the CM201-9 handle.
Lock the cannula in place by turning the screw on
the handle.
Connect the handle to the "socket for the handle
CM201-9" of the pump.
Connect the suction tube to the central vacuum.
Connect the other side of the suction tube to the
suction port of the cannula.
Place the tube in the suction interruption
mechanism.
Place the black cap over the entire mechanism
(not shown).
Connect the cable to the socket on the device.
Connect the cable to the mains using a 230 Volt
socket.
Turn on power switch located on the back of the
device.
Your device is ready to be used.
Start the circuit by pushing the switch under the
handle and control the flow rate as needed by
turning knob 'Flow rate controller'.
Figure 1 Assembly (2/2)
Page 37 sur 91