GE AEG14 Manual Del Propietario E Instrucciones De Instalación página 12

Installation Instructions
5. PREPARE THE WINDOW AND
INSTALL THE CASE
A.
Cut the window sash seal to the proper length.
Peel off the backing and attach the seal to the
underside of the window sash.
B.
Open the window and mark the center of the
window sill.
C.
Carefully slide the case into the window and
center the case. Lower the window behind the
top mounting rail. Pull the bottom of the case
forward so that the bottom mounting rail is tight
against the back of the window stool. Mount the
Drill pilot holes, if necessary.
Stool
D.
Assemble the V-support and V-support bracket
with Type F nut and bolt
Sill angle
bracket
V-support
Type F bolt
and nut
12
Type E bolt
and nut
Right
5. PREPARE THE WINDOW AND
INSTALL THE CASE (continues)
E.
Position the V-supports on
the case bottom so that they
will be near the outside wall.
Attach a V-support to each
side of the bottom of the
case with Type E bolts, 2 for
each support.
F.
Adjust sill angle brackets to rest on sill.
G.
vertical window sashes. Drill pilot holes and attach
the top corners with 2 type C screws.
Type C
screw
V-support
Sill
Type C
screw
49-5000434