Check Kennel Alignment; Assemble Center Connector, Center Brace And 28.5 Inch (72.3Cm) Tubing; Install Center Roof Assembly To Kennel - Petsafe Grandview Dog Kennel Roof Instrucciones De Armado

Check Kennel Alignment

Step
1
For the best roof fi t, the kennel should be squared, which means that each kennel corner is at a 90
degree angle.
1. Using the measuring tape, measure the kennel diagonally from corner to corner. If your measurement
is less than or equal to one half inch (13mm), your kennel is square.
2. If your measurements exceed one half inch, adjust the kennel so that each corner is close to a 90
degree angle. Measure the kennel again and continue to make adjustments until the kennel is square.
Assemble Center Connector, Center
Step
2
Brace and 28.5 inch (72.3cm) Tubing
1. Gather Center Connector, (2) Center Brace
tubes and (2) 28.5 inch (72.3cm) tubes.
2. On the ground, insert the (2) center brace
tubes on the angled sides of the center
connector. The welded plate at each end of
the center brace tubes should face down.
3. Insert the (2) straight tubes on the straight
sides of the center connector.
Step

Install Center Roof Assembly to Kennel

3
1. Turn around the top clamp on each 10 foot
(3.05m) side of the kennel so that the screw
head faces outside and the bolt and nut faces
the inside. Leave the connection loose.
2. Take the center roof assembly built in Step
2 and place the center brace tubes on top
of the loosened center clamps on top of the
kennel (3A).
4
2A
3A
1-888-632-4453