Fit The Tarp On The Roof Frame; Secure The Tarp To The Kennel - Petsafe Grandview Dog Kennel Roof Instrucciones De Armado

Fit the Tarp on the Roof Frame

Step
5
1. Gather the tarp.
2. Unfold the tarp and turn it right side up.
3. Start on the inside of the kennel. Place the tarp over the roof frame
on one end of the kennel. Fit the grommet located at the peak
of the SunBlock
Repeat this step on the opposite side and ensure that the grommets
properly fi t on the elbow pins.
4. Drape the sides of the tarp on the outside of the kennel side panels.

Secure the Tarp to the Kennel

Step
6
1. Gather (4) Bungee Balls and (18) Cable Ties.
2. Attach one bungee ball to each of the four
sides of the kennel at the corners. Fit the
bungee balls through the grommets on the
tarp and around the kennel side rail (6A).
3. Attach the sides of the tarp to the kennel
using (8) cable ties. Loosely attach each
cable tie through a tarp grommet and
around the wire mesh. Once the cable ties
are in place, tighten them and snip off any
excess using the wire cutters.
4. Secure the SunBlock
of the roof to the top rail of the kennel using
(6) cable ties. When attaching the cable tie
to the center grommet of the SunBlock
each end of the kennel, be sure to insert the
cable tie through the hole on the upright
tube with clamp. Tighten the cable ties until
you put tension on the SunBlock
The bottom of the SunBlock
designed to touch the top of the kennel rail
(6B). Save any remaining cable ties in a safe
place for future use.
Important: Tarp is not designed to withstand the weight of
snow. Remove cover in winter. Kennel anchors are strongly
recommended. PetSafe
6
™ panel onto the plastic pin on the elbow (5A).
™ panels on each end
™ panel.
™ panel is not
Anchor Kit sold separately.
®
1-888-632-4453
6A
™ on
6B
5A