Hama 00178239 Instrucciones De Uso página 2

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions
and information completely. Please keep these
instructions in a safe place for future reference.
1. Explanation of Warning Symbols and Notes
Risk of electric shock
This symbol indicates product parts energized
with a dangerous voltage of su cient magnitude
to constitute a risk of electric shock.
Warning
This symbol is used to indicate safety instructions
or to draw your attention to speci c hazards
and risks.
Note
This symbol is used to indicate additional
information or important notes.
2. Package Contents
• Car Charger (USB-A), QC 3.0, 2.0
• These operating instructions
3. Safety Notes
• This product is intended for private, non-
commercial use only.
• When using this product, observe the applicable
local tra c laws and regulations.
• Take care that components such as airbags, safety
areas, controls, instruments, etc. and visibility are
not blocked or restricted.
• Do not allow yourself to be distracted by the
product when driving a vehicle. Always pay
attention to the surrounding tra c and your
environment.
• Protect the product from dirt, moisture and
overheating, and only use it in a dry environment.
• Do not drop the product and do not expose it to
any major shocks.
• Do not operate the product outside the power
limits given in the speci cations.
• Do not modify the device in any way. Doing so
voids the warranty.
• Do not continue to operate the device if it
becomes visibly damaged.
• Use the product for its intended purpose only.
• Keep this product, as all electrical products, out of
the reach of children!
• Do not bend or crush the cable.
2
• Always pull directly on the plug when
disconnecting the cable, never on the cable itself.
• Do not use the product in the immediate vicinity
of heaters or other heat sources or in direct
sunlight.
• Dispose of packaging material immediately
according to locally applicable regulations.
Risk of electric shock
• Do not open the device or continue to operate
it if it becomes damaged.
• Do not use the product if the charging cable,
adapter cable or power cable is damaged.
• Do not attempt to service or repair the product
yourself. Leave any and all service work to
quali ed experts.
4. Operation
Note – Mains voltage 12 – 24 V
The charger is suitable for a mains voltage of
12 – 24 V.
Warning – Connecting terminal
devices
• Before connecting a terminal device, check
whether the power output of the charger can
supply su cient power for the device.
• Ensure that the power of the connected
terminal device does not exceed 18 W.
• Please refer to the instructions in the operating
manual of your terminal device.
Note – QC 3.0, 2.0
• Plug & go: No manual setup necessary, just
connect and start:
Voltage and power are automatically
con gured by QC 3.0, 2.0.
• For e cient and optimised charging, the QC
3.0, 2.0 function must be supported by your
terminal device.
• With the large quantity of QC-enabled terminal
devices with different rmware versions, it can
happen that the function is not fully supported.