Selecting Camera Transmission Image; 11 Noise Sensitivity Setting; 12 Selecting The Frequency - Beurer BY 110 Instrucciones De Uso

7.10

Selecting camera transmission image

If you wish to select the transmission image of a camera, proceed as follows:
• Press the (
• Use the direction buttons (
• Confirm using the ( OK ) button� On the screen you will see 1, 2, 3, 4 or
(alternating camera transmission image)�
• Use the direction buttons (
which you wish to view or
transmission image�
• Confirm using the ( OK ) button�
Note
If you have registered multiple cameras, the "
mission image" function is available� When this function is activated, the
transmission images from the registered cameras appear on the screen of
the parent unit in the form of a loop that changes every 5 seconds�
7.11 Noise sensitivity setting
The noise sensitivity setting on the baby unit determines what you can
hear on the parent unit� If you set the sensitivity level to high (H), you will
hear even very quiet noises via the parent unit� If you set the sensitivity
level to medium (M), you will hear medium-loud noises via the parent unit�
If you set the sensitivity level to low (L), you will only hear very loud noises
via the parent unit�
To change the sensitivity level, proceed as follows:
• Press the (
• Use the direction buttons (
• Use the direction buttons (
( H = high, M = medium or L = low)�
• Confirm using the ( OK ) button�
7.12 Selecting the frequency
The baby unit can either transmit to the parent unit at 50 Hz or 60 Hz� The
frequency which is most common in Europe (50 Hz) has been preset� Choos-
) button�
) button�
) / ( ) to select menu item
) / ( ) to select the number of the camera
, if you wish to view an alternating camera
) / ( ) to select menu item
) / ( ) to select your desired sensitivity level
37
alternating camera trans-
�
�