Finding A Passage Within A Track; Different Play Modes; Shuffle And Repeat; Programming Track Numbers - Philips MZ–5 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

XP MZ5/37
15-03-2002 11:23
CD Player

Finding a passage within a track

1 Press and hold down on ¡1 or 2™
(on the remote control 11 or 22).
– The CD is played at high speed and low
volume.
2 When you recognize the passage you want,
release 11 or 22.
– Normal playback continues.
Note: During a CD program or if SHUFFLE/ REPEAT
active, searching is only possible within the same
track.

Different play modes:

SHUFFLE and REPEAT

You can select and change the various play
modes before or during playback.The play
modes can also be combined with PROGRAM.
SHUFFLE
SHUFFLE and
REPEAT ALL
REPEAT ALL
REPEAT
1 To select your play mode before or during
playback, press either:
• on the remote control SHUFFLE or
REPEAT;
• on the set CLOCK repeatedly until the
display shows the desired function.
2 Press 2; to start playback if in the STOP
position.
If you have selected SHUFFLE, playback starts
automatically.
3 To return to normal playback, press the
respective SHUFFLE or REPEAT button until
the various SHUFFLE/ REPEAT modes are no
longer displayed.
– You can also press 9 to cancel your play
mode.
14
Pagina 14
tracks of the entire
CD/ program are played in
random order
to repeat the entire
CD/ program continuously in
random order
repeats the entire
CD/ program continuously
repeats the current track
continuously

Programming track numbers

MC 158 CO MP
MC 158 CO MP
AC T AU DIO
AC T AU DIO
IO
IO
IO
IO
SYS TEM
SYS TEM
IO
IO
II
II
CD
DBB
SHUF FLE
IO
IO
PROG RAM
II
II
IO
IO
II
II
IO
IO
II
II
IO
IO
IO
IO
I II
I II
Program in the STOP position to select and store
your CD tracks in the desired sequence.
If you like, store any track more than once.
Up to 40 tracks can be stored in the memory.
1 Press PROGRAM on the set or remote control
to enter the programming mode.
A track number is shown and
flashes.
2 Use the ¡1 or 2™ on the set, (on the remote
control ¡ or ™) to select your desired track
number.
3 Press PROGRAM to confirm the track number
to be stored.
The number of tracks programmed and total
playing time of the program is shown briefly,
then the selected track and PROG.
··· : ··· is shown if total playing time is
100 minutes or more.
4 Repeat steps 2-3 to select and store all desired
tracks.
FULL is displayed if you attempt to
programe more than 40 tracks.
5 To start playback of your CD program,
press 2; .

Reviewing the program

In STOP mode, press and hold down
PROGRAM on the set or remote control, until
the display shows all your stored track numbers
in sequence.
OPEN
OPEN
CLOSE
CLOSE
PRESET
PRESET
TUNING
TUNING
PROGRAM

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido