General Specifications; Electrical Specifications; General Safety Information - GAMCO DR-5750 Manual Del Usuario

Secamanos empotrado
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Description
Gamco recess mounted, ADA compliant warm air hand dryer, powered by a high speed universal motor, delivering 2300 Watts of drying
power. This hand dryer runs on 115 Volts AC, 208/220-240 Volts AC, or 277 volts AC electrical supply, depending on model. Automatic
and push-button models are represented in this product group. This appliance is intended for use in hand drying, contributing to hygienic
and cost effective hand sanitation. This hand dryer may be used in commercial, industrial, office and public facility environments.

General Specifications

Basic Models
Nozzle
DR-5750
Fixed

Electrical Specifications

Models
Type
DR-5750
Automatic

General Safety Information

DANGER
• Always disconnect the power source before servicing or installing the hand dryer.
DANGER
• This hand dryer must be properly grounded (Earthed) for safe operation. An identified ground connection point is supplied on the
hand dryer's wall base.
• We recommend GFCI protection in wet or damp locations or as required by local code.
WARNING
• Use only the electrical power (voltage and frequency) specified for the model hand dryer being installed.
• Connect the hand dryer to the nearest suitable distribution panel.
• To limit a voltage drop, and insure efficient operation, use wire gauge as required by local or National Electrical Code.
• Do not connect to a branch circuit with CB or fuse protection over 20 Amps. This is in compliance with The National Electrical Code
#210-20.
• All automatic model hand dryers must have a dedicated 20 Amp circuit as required by Underwriters Laboratories, Inc. (UL).
• Route all field wiring away from any moving parts within the hand dryer.
CAUTION
Unpacking
1. Remove all packing material. Recycling is recommended.
2. Carefully remove the hand dryer from the shipping carton, using care not to drop the appliance.
3. Inspect carefully for any damage that may have occurred during transit. Check for any loose, missing or damaged parts. If the hand
dryer is damaged, promptly inform the shipper or dealer where you purchased it.
Form No. DR-5750
68-10216 rev01
Drying Cycle
Dimensions (WxDxH)
Automatic
13.1" x 13.8" x 4"
Electrical Input
115 VAC, 60 Hz
Failure to disconnect the power source before installation or servicing can result in
serious injury or death from electric shock.
Failure to properly ground this unit could result in severe electrical shock and/or
death.
Risk of fire, personal injury or property damage are possible if local codes, NEC
codes or safety recommendations are not followed.
Improper mounting could result in personal injury or property damage.
(Rev. 10/7/13)
© 2013 Gamco Commercial Restroom Accessories, A Division of Bobrick
333 mm x 351 mm x 102 mm
Amperage
Watts
20
2300
2
Weight
Cover Material
35 lbs / 15.9 kgs
Cast Iron
(cULus Listed, E43125, CE TUV-GS)
Printed in U.S.A.

Publicidad

Tabla de contenido
loading

Tabla de contenido