Nozzle Cleaning; Accessories; Repairs - Excell VR1600E Manual De Instrucciones

NOZZLE CLEANING

If the nozzle becomes clogged with foreign matter, such as dirt, excessive
pressure may develop. If the nozzle becomes partially clogged or restricted, the
pump pressure will pulsate. Clean the nozzle immediately using the nozzle kit
supplied and the following instructions:
1. Place the ON/OFF switch in the OFF position and turn off the water supply.
2. Unplug unit from power source
3. Pull trigger on gun handle to relieve any water pressure.
4. Disconnect the wand from the gun.
5. Clean the nozzle using the nozzle cleaner provided or a straightened paper
clip. Insert into the nozzle end and work back and forth until ob struc tion is
re moved.
6. Direct water supply into nozzle end to backflush loosened particles for 30
seconds.
7. Plug unit into appropriate outlet.
8. Reassemble the nozzle to the wand. Tighten securely to prevent leaks.
9. Reconnect wand to gun and turn on water supply.
10. Start pressure washer and place wand into high pressure setting to test.
Recommended accessories for use with your pressure washer are available
for purchase from your local retailer or authorized service center. If you need
assistance in locating any accessory for your tool, please call
visit our website
branded accessories rated equal to or greater than the rating of the pressure
washer.
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
should be performed by an Authorized Warranty Service Center. Always use identical
replacement parts. For the location of the nearest Authorized Warranty Service
Center call 1-800-888-2468 or visit our website www. excellpressurewasher.com.

ACCESSORIES

www.excellpressurewasher.com
The use of any other accessory not recommended for
use with this tool could be hazardous. Use only EXCELL
.

REPAIRS

15 - ENG
or
1-800-888-2468
A17913