Maintenance; Nozzle Cleaning - Excell VR2522 Manual De Operación

All manuals and user guides at all-guides.com
Risk of property
damage. NEVER
turn the water off with the engine
running.
3. Turn water source off.
Risk of burn hazard.
When performing
maintenance, you may be exposed
to hot surfaces, water pressure or
moving parts that can cause serious
injury or death.
Risk of fire hazard.
Always disconnect,
spark plug wire, let the engine
cool and release all water pressure
before performing any maintenance
or repair. The engine contains
flammable fuel. Do not smoke or
work near open flames while
performing maintenance.
To ensure effi cient operation and
longer life of your pressure washer, a
routine maintenance schedule should
be prepared and followed. If the
pressure washer is used in unusual
conditions, such as high-temperatures
or dusty conditions, more fre quent
maintenance checks will be required.
ENGINE
Consult the Engine Owners Manual for
the man u fac tur er's recommendations
for any and all maintenance. NOTE:
The engine drain plug is located at the
rear of the unit.
PUMP
The pump on this unit is maintenance
free and requires no oil, if there is a
problem with the pump contact an
Authorized Service Center.

NOZZLE CLEANING

If the nozzle becomes clogged
with foreign matter, such as dirt,
excessive pressure may develop. If
the nozzle becomes partially clogged
or restricted, the pump pressure will
pulsate. Clean the nozzle immediately
using the nozzle kit supplied and the
following instructions:
4. Pull trigger on spray gun to relieve
any water pressure in hose or spray
gun.
5. See Storage section in this manual
for proper storage procedures.

MAINTENANCE

1. Shut off the pressure washer
and turn off the water supply.
2. Disconnect spark plug wire to
insure the unit will not start while
performing maintenance.
3. Pull trigger on gun handle to
relieve any water pressure.
4. Disconnect the wand from the
gun.
5. Remove the nozzle from the
end of the wand with the 2mm
allen wrench provided as shown.
6. Clean the nozzle using the nozzle
cleaner provided or a straightened
paper clip. Insert into the nozzle
end and work back and forth until
ob struc tion is re moved.
7. Direct water supply into nozzle
end to backfl ush loosened
particles for 30 seconds.
8. Reconnect spark plug wire
9. Reassemble the nozzle to
the wand. Tighten securely to
prevent leaks.
10. Reconnect wand to gun and
turn on water supply.
11. Start pressure washer and
place wand into high pressure
setting to test.
13 - ENG
A16637