Extension Cord Use - Salton GEORGE FOREMAN GGR50 Manual Del Usuario

We do not recommend the use of an extension cord, however if an extension
cord is required special care and caution is necessary. The cord must be a 14
Gauge, Three (3) Conductor type marked with an electrical rating of 120V, 15A,
1875W, and arranged so that it will not drape over the countertop or table top
where it can be pulled on by children or tripped over accidentally.
If the electric circuit is over loaded the circuit breaker will trip and your
appliance will not operate. It should be operated on a 20amp electrical circuit
separate from other appliances.
1. Wash the Base, Grill, Grease Tray, and Lid in warm soapy water. Rinse and
dry thoroughly. DO NOT IMMERSE TEMPERATURE CONTROL PROBE. Wipe
with a damp cloth and dry thoroughly.
2. Place the Pedestal Base on a flat, level surface.
3. Insert the slotted end of the Pedestal Tube into the hole in the center of the
foot and push down firmly.
4. Place the Base on top of the Pedestal Tube, with the hole in the center of
the Base engaging with the Tube.
5. Place the Grease Tray securely into position inside the Base. When
properly placed, it is held firmly with the pointed end over the center of the
Base.
6. Position the Grill securely into the Base, with the probe receptacle fitting
through the probe cutout in the top side of the Base.
7. Attach the Lid Handle to the Lid from inside the Lid with the Rubber-Ringed
Fastener.
8. Place the Lid over the Grill. Your Barbeque Grill is now ready to use.

Extension Cord Use

Electrical Power
Assembly Instructions
4