Preparing The Watch For Use; Using The Chronograph - Breitling Chronomat 01 Manual Del Usuario

PREPARING THE WATCH FOR USE

WINDING – TIME-SETTING
1. Unscrew the water-resistant crown in an anti-clock-
wise direction. Wind the watch by 40 clockwise
turns of the crown.
2. Pull the crown out to position 2, turn it clockwise to
adjust the calendar to the day prior to the date
when it is set into operation.
3. Pull the crown out to position 3. Turn the hands so
as to make the calendar jump once when the hands
pass through midnight. Then adjust the hour and
minute.
4. Push the crown back to position 1. Press it gently,
turning it gently in a clockwise direction, then
tighten it again until you feel some resistance. Do
not force!
16

USING THE CHRONOGRAPH

I. M
EASURING A SINGLE SHORT TIME
Your chronograph is equipped with security pushpieces which ensure
enhanced water-resistance and provide effective protection against shocks.
Consequently, pushpieces should only be activated after unscrewing the
retaining ring.
Nota bene: it is important to keep the pushpieces
screwed in when the chronograph is not in use.
1. Press pushpiece A to start the chronograph. Hand 3
shows the measurement in seconds.
2. Stop the measurement by pressing pushpiece A once
more. The measurement is done in hours (totalizer
1), minutes (totalizer 2), seconds and 1/4 of a second
(hand 3).
3. Return the chronograph to zero by pressing push-
piece B.
17